24
The JamMan
®
Stereo is designed to be very simple to use right out of the box.
This section explains how to record a phrase and play it back as a continuous
loop. You should have an instrument or audio device connected to the 1/4”
inputs or a mic connected to the XLR mic input before proceeding.
NOTE: The maximum loop time the JamMan Stereo can record or play is
10 minutes.
Select an empty memory location using the 1. LOOP SELECT knob or the
LOOP UP/LOOP DOWN footswitches (the LOOP and SINGLE LEDs will be off).
(Optional) If you would like to perform to a guide track, you must set a 2.
tempo. The rhythm guide track will not be heard until a tempo has been
set. You can set a tempo by tapping the TEMPO/STOP footswitch. Adjust
the RHYTHM LEVEL knob to a suitable volume. The TEMPO/STOP footswitch
will now be flashing at the set tempo (see page 42).
(Optional) Set the Time Signature to something other than 4/4, if desired 3.
(see page 40).
Press the 4. REC/PLAY/OVERDUB footswitch and begin playing or singing to
start recording. If a tempo has been set, there will be a single measure
count-in indicated by the TEMPO footswitch before recording begins. The
REC/PLAY/OVERDUB footswitch will then light solid red, the LOOP LED
will light, and recording will start. If no tempo has been set, recording
will begin instantly after the REC/PLAY/OVERDUB footswitch is pressed and
you begin playing.
When you are ready to set the loop point for your phrase, press the 5.
REC/PLAY/OVERDUB footswitch to set the loop point and have the phrase
play back in a repeating loop. The REC/PLAY/OVERDUB footswitch and
PLAY status LEDs will light solid green.
Press the 6. TEMPO/STOP footswitch to stop the loop playback.
Once you are finished recording, the STORE button will be lit indicating the
phrase must be stored to memory to be recalled later.
Recording a Loop - Inst/Mic Input
To Next Page
Loading...
Need help?
General
Weight and Dimensions
