DigiTech JAMMAN STEREO User Manual

46
Any phrase recorded into the JamMan
®
Stereo can be played in two ways:
Either as a continuous Loop, or as a Single “one-shot” sample.
Single phrases are designed to play the recorded phrase only once and stop.
All phrases are recorded as loops by default but they can be changed to a
Single phrase if desired. You can always change Single phrases back to Loops
later without harming the phrase. To change between Single and Loop, follow
these steps:
Select a previously recorded Loop phrase (1. LOOP LED is lit) using the
LOOP UP/LOOP DOWN footswitches or SELECT knob. If the CARD MEM LED is
lit, you have selected a memory location on the optional memory card.
Enable the 2. SHIFT button and then press the LOOP/SINGLE button to select
the SINGLE LED or the LOOP LED depending on how you want the phrase
to play back.
Press 3. EXIT.
The 4. STORE button will light to indicate this change must be stored if it is
to be recalled later. Press the STORE button twice to store the changes, if
desired.
Single phrases cannot have overdubs added to them. Repeated presses of
the REC/PLAY/OVERDUB footswitch will just restart the Single phrase playback
from the beginning.
Loop / Single Phrases

DigiTech JAMMAN STEREO Specifications

General

Type	-
Bit rate	24 bit
Proper use	DJ
Sample rate	44.1 kHz
Product color	Blue
Power consumption (typical)	9 W

Weight and Dimensions

Depth	173.73 mm
Width	170.18 mm
Height	73.4 mm
Weight	1006 g