DigiTech JAMMAN STEREO User Manual

52
Erase All Loops - Internal Memory
The JamMan
®
Stereo uses both internal memory and optional card memory
for the storage of loop files. You can erase all loops from internal memory
or from card memory without having to delete them one at a time.
To erase all loops from internal memory, follow these steps:
Select a loop memory location that does not light the 1. CARD MEM LED.
Enable the 2. SHIFT button.
Press and hold the 3. DELETE button for four seconds until Ei (Erase
Internal Memory Loops) appears in the Display and release (EL will
show briefly first but keep holding the button until Ei appears). The
DELETE
button will begin flashing.
Press the 4. DELETE button again. The DISPLAY reads E? (Erase Loops?).
The DELETE button will continue to flash. To abort this procedure,
press the EXIT button.
To erase all internal loop memories, press and hold the5. DELETE button
for two more seconds. The DISPLAY will show Bu indicating the card
is being erased. When the delete procedure is complete the display
will return to the memory number and the EXIT and DELETE buttons
will turn off.

DigiTech JAMMAN STEREO Specifications

General

Type	-
Bit rate	24 bit
Proper use	DJ
Sample rate	44.1 kHz
Product color	Blue
Power consumption (typical)	9 W

Weight and Dimensions

Depth	173.73 mm
Width	170.18 mm
Height	73.4 mm
Weight	1006 g