26
Managing Songs
Clearing Multiple Songs
To clear multiple songs:
1. Stop playback by pressing and holding the FOOTSWITCH for ~2 seconds (or until the PLAY LED and KICK/
SNARE pads begin flashing).
2. Press the SONG button to enter song mode.
3. Select the song to clear by turning the HATS/RIDES encoder.
TIP: Continue turning the HATS/RIDES encoder beyond the 12 and 1 selections to toggle through the
three song banks: bank 1 (green LEDs), bank 2 (amber LEDs), and bank 3 (red LEDs).
4. Press and hold the SONG button for ~2 seconds (or until all PART buttons flash red rapidly), then release.
5. The song has now been cleared and is empty.
TIP: A song can be restored in song mode as long as the SDRUM has not been power cycled or any
other operations performed since the song was cleared.
To restore a song after clearing it in song mode, immediately press and hold the SONG button for ~2
seconds (or until all PART buttons flash rapidly), then release. The LEARN LED will go off and the PLAY
LED will light to indicate the song is again available.
6. Repeat steps 3 and 4 to clear any additional songs.
To Next Page
Loading...
Need help?
General
