User Manual
Then, you will enter Tag Base VLAN Group Setting or Port Base VLAN
Group Setting page, which depends on your VLAN mode selection.
VID:
VLAN identifier. Each tag-based VLAN group has a unique VID. It
appears only in tag-based mode.
Member:
In modify function this is used to enable or disable if a port is a member
of the new added VLAN, “Enable” means it is a member of the VLAN.
Just tick the check box (
;) beside the port x to enable it.
Fig. 4-7 Port-Based VLAN Configuration
Add Group:
Create a new port-based VLAN or tag-based VLAN, which depends on
the VLAN mode you choose in VLAN mode function.
Publication date: Septembery, 2007
Revision A3
58
To Next Page
Loading...
