29
After you click “Push Button Config(PBC)”, a message box will appear:
Please activate Push-Button function on wireless access point now, and wireless
network card will establish secure connection with access point within one minute.
CHAPTER 4 Soft-AP Function
Excepting become a wireless client of other wireless access points, this wireless
adapter can act as a wireless service provider also! You can switch this wireless
adapter’s operating mode to ‘AP’ mode to simulate the function of a real wireless
access point by software, and all other computers and wireless devices can connect
to your computer wirelessly, even share the internet connection you have!
Please follow the instructions in following chapters to use the AP function of your
wireless card.
4.1 Switch to AP Mode and Station Mode
The operating mode of the wireless card is ‘Station Mode’ (becoming a client of other
wireless access points) by default.
Please follow the following instructions to switch to AP mode:
1. Right-click Client configuration utility icon, and click ‘Open Config Utility’.
2. Select ‘Mode’, and then select ‘Access Point’.
It requires few seconds to switch to AP mode, please be patient.
To Next Page
Loading...
Need help?
General
