EN
page 36
Disconnect electricity and water before disposal.
Cut away the electrical cable to ensure that further use is impossible.
All metal parts are recyclable as they are made of stainless steel.
Recyclable plastic parts are marked with the plastic material symbol.
10. TROUBLESHOOTING
Type of Problem Possible Causes Cure
The machine does not
turn on.
Main switch not ON. Turn switch ON.
The machine does not
load water
Water valve shut. Open the hot and/or cold water valve.
Solenoid-valve fi lter blocked Clean the fi lter
Overfl ow pipe not in place Check the correct placement of the overfl ow pipe.
Defective pressure-switch. Replace pressure-switch.
START button A fl ashing
(red colour)
See chapter 8 Alarms. ---
Washing results are
unsatisfactory
The washing nozzles are obstructed
or the rack does not rotate.
Clean the nozzles carefully, and check the right positioning
of the wash-arm, tightening fi rmly.
Foam is present. Use no-foam detergents or reduce the dose in use. Check
the rinse-aid dosage.
Fats or starches not removed. Insuffi cient detergent concentration.
Filters are dirty. Remove fi lters, clean with brush under a jet of water and
replace in original position.
Check tank temperature (which
must be between 50°C and 60°C).
Adjust the thermostat or check correct heating element
operation.
Wash time insuffi cient for the type
of dirt.
Select a longer wash-cycle, if possible, otherwise repeat
the wash cycle.
Wash water is dirty. Drain the tank water, clean the fi lters; refi ll the tank and
replace the fi lters correctly.
The objects are not
properly dried.
Not enough rinse aid. Increase dosage by turning the dispenser screw (see par.
Rinse aid dispenser).
The rack is not suitable for the
objects.
Use the suitable rack which gives the objects an inclined
position so that water can rinse away.
The washed items may have been
sitting in the wash chamber too
long.
As soon as the cycle stops, remove the rack with the objects
so that they can dry more quickly in the air.
Rinse temperature under 80°C. Check the boiler thermostat temperature.
Surface of objects too rough or
porous for material wear.
Replace type of the objects used. If the dirt on the object is
dry and old, soak before washing.
Streaks and spots on
glasses and dishes
Too much rinse-aid chemical. Reduce the rinse aid amount by turning the micrometric
dispenser screw (see par. Rinse aid dispenser).
Too hard water. Check the water quality. Water must not exceed 5-8°f in
hardness
The machine suddenly
stops during operation.
The machine is connected to an
overload device.
Connect the machine on a own overload device (call
Service).
A machine safety device was
triggered.
Check the electrical devices (call Service).
To Next Page
Loading...