20
the throttle is under "non-zero startup"where the throttle will only activate the motor
to activate the motor when triggered.
P5 Power Monitoring Setting
The P5 parameter setting will display on the meter after the P4 parameter setting has
P5 Display
monitoring is in "real-time voltage" mode where the method to determine the battery
the power monitoring is in "smart power" mode where the value set is determined by
4-11 and 36V lithium batteries set between 5-15. The P5 parameter setting ranges from
C PARAMETER SETTING
Use
C parameter settings.
KUNTENG
Power Assist
Sensors
C1
Value
Start
Sensitivity
KUNTENG V12
Power Assist Sensors
C1
Value
Start
Sensitivity
Forward 5 Signal 00 Standard Reverse 6 Signal 05 Standard
01 Lower 06 Lower
02 Lowest 07 Lowest
Forward 8 Signal 00 Higher Reverse 10 Signal 05 Higher
01 Standard 06 Standard
02 Lower 07 Lower
Forward 10 Signal 00 Highest Reverse 12 Signal 05 Highest
01 Higher 06 Higher
02 Standard 07 Standard
To Next Page
Loading...
Need help?
General