22
C2 Motor Phase Classication Coding Mode
C2 Display
C3 Display
C3 Power Assist Ratio Gear Initialization
C3 parameters are settings for the power assist ratio gear upon start-up, where if the
rider desires the bike to start up with a power assist ratio gear of 3, the C3 setting
Production errors produced additional settings of 6-8.
The C2 parameter setting will display on the meter after C1 settings. The KT-LCD3 will
display as follows:
The C3 parameter setting will display on the meter after C2 settings. The KT-LCD3 will
display as follows:
To Next Page
Loading...