9
leases from the ledge located
at the bottom of the partially
reective glass (Figure 3).
!
NOTE: Log set ts tightly into
rebox, some force may be nec-
essary to remove.
4. Set logset in front of rebox.
5. Disconnect the logset LED
wire harness from unit
(Figure 4).
6. Examine the bulbs to de-
termine which bulbs require
replacement.
7. Unscrew bulbs counter clock-
wise.
8. Insert new bulbs.
9. Re-connect the logset LED
wire harness to the unit.
10. Replace the log by inserting
the rear tab of the logset un-
der the back ledge of the re-
place and push down on the
front edge of the logset until it
snaps into place (Figure 3).
11. Replace log grate using two
screws previously removed.
Purire™ Filter
The Purire™ lter supplied in
your replace is reusable and
washable. The lter should be
cleaned or replaced on average
once a year, or if overheat indica-
tor lamp is activated. To clean
the lter gently tap lter on a hard
surface to dislodge any loose dirt
or debris, and then clean with
water. Do not use soap or clean-
ing products, as they may dam-
age the lter. The lter size is 20”
X 10” X 1” rated at MERV 10. If
using an after market lter follow
the manufacturers recommended
replacement instructions.
To replace lter:
Maintenance
Side Section
Back
Ledge
Rear
Tab
Log
Ember
bed
Front
Edge
LED Wire
Harness
Figure 3
Figure 4
To Next Page
Loading...
Need help?
General
