To Next PageTo Next PageWhy is my Dimplex BF33STP Indoor Fireplace flame not bright?
If the flame in your Dimplex Indoor Fireplace is not bright or not visible, it could be due to burnt light bulbs, which you should replace. Also, check the wiring connections for any looseness. If the issue persists, the light harness might be defective and need replacement.
Why does my Dimplex BF33STP Indoor Fireplace trip the circuit breaker?
Your Dimplex Indoor Fireplace might be tripping the circuit breaker due to a short in the unit's wiring. You should trace the wiring in the unit to identify and fix any shorts. Alternatively, the circuit may have an improper current rating; verify that the unit is installed on a dedicated 15 amp circuit.
Why does my Dimplex Indoor Fireplace heater emit an odor?
A Dimplex Indoor Fireplace heater may emit an odor for a brief period after being initially turned on, which is normal. This occurs as the heater burns off any dust accumulated during manufacturing or operation. However, if the odor persists, the heater assembly may be defective and require replacement.
Why is my Dimplex BF33STP Indoor Fireplace heater fan running continuously?
If the heater fan in your Dimplex Indoor Fireplace runs continuously, the heater on/off switch may be defective and need to be replaced. It could also be due to defective Thermostat/Wall Controls, which would also need replacing.
Why is my Dimplex BF33STP heater not turning off?
If the heater on your Dimplex Indoor Fireplace is not turning off, first, ensure you are operating the unit correctly. If applicable, verify the proper operation of the Thermostat/Wall Controls. If the problem persists, the heater on/off switch or the heater assembly might be defective and require replacement.
What to do if my Dimplex Indoor Fireplace is not turning on with the wall mounted remote?
If your Dimplex Indoor Fireplace isn't turning on with the wall-mounted remote, start by ensuring proper operation. Then, check if the remote control is initialized to the fireplace and initialize it if necessary. If it still fails, install a new battery into the wall mounted remote control and reinitialize the remote. If the issue continues, the Remote Control Receiver Kit might be defective and require replacement.
What to do if my Dimplex Indoor Fireplace is not turning on with the remote control?
If your Dimplex Indoor Fireplace isn't turning on with the remote control, first, ensure you are operating it correctly. Then, check if the remote control is initialized to the fireplace; if not, initialize it. If it still doesn't work, try installing a new battery into the remote control and reinitializing it. If the problem persists, the Remote Control Receiver Kit might be defective and need replacement.
Why is my Dimplex Indoor Fireplace heater turning off after a few minutes?
If your Dimplex Indoor Fireplace heater turns off after a couple of minutes, it could be due to a buildup of dirt or dust in the heater assembly; ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. Alternatively, the Heater Assembly might be defective. In this case, replace the Heater motor (if it's not running when heat is activated) or the Heater Elements (if the motor is running but heat isn't coming out).
What to do if my Dimplex BF33STP Indoor Fireplace is not turning on manually?
If your Dimplex Indoor Fireplace isn't turning on manually, start by making sure you are operating it correctly. Check the fuse/breaker panel to ensure there's incoming voltage from the electrical wall socket. Inspect the wiring connections for any looseness. If these steps don't resolve the issue, the On/Off Switch or the 3-Position Switch might be defective and require replacement.
Why does my Dimplex BF33STP Indoor Fireplace turn on and off by itself?
Your Dimplex Indoor Fireplace might be turning on and off by itself for several reasons. The remote control may have a similar frequency to other remotes in the area; if so, replace the remote control. If you have a wall-mounted remote, its frequency might be interfering; try changing the RF frequency and reinitializing it. Radio frequency disturbance from outside sources could also be the cause, in which case you should replace the remote control and Remote Control Receiver Kit, where necessary. Finally, a defective Remote Control Receiver Kit could be the culprit, and replacing it may solve the issue.
General| Brand | Dimplex |
|---|---|
| Model | BF33STP |
| Category | Indoor Fireplace |
| Language | English |
