What to do if my Dimplex PF3033 Indoor Fireplace shuts off or beeps when the heater is on?
If your Dimplex Indoor Fireplace shuts off or beeps when the heater comes on, it might be due to a power surge interference. Try unplugging the unit for 15 minutes to allow it to de-energize and reset the main control board. Consider installing a power regulator board between the main control board and the heater assembly.
What to do if my Dimplex PF3033 heater emits an odor?
It's normal for the Dimplex Indoor Fireplace heater to emit an odor briefly when initially turned on, as it burns off dust accumulated during manufacturing or operation. If the odor persists, the heater assembly may be defective and require replacement.
Why do lights dim in room when my Dimplex PF3033 is on?
The lights may dim because the Dimplex Indoor Fireplace is drawing close to the circuit's current rating. To resolve this, move the unit to another outlet or install it on a dedicated 15 amp circuit.
What to do if Dimplex PF3033 Indoor Fireplace does not turn on with the remote?
If your Dimplex Indoor Fireplace is not turning on with the remote control, first refer to the Operation Section for proper usage. If the issue persists, install a new battery into the remote control. If that doesn't work, the remote control or the floating display assembly might be defective and need replacement.
Why does my Dimplex PF3033 Indoor Fireplace heater emit an odor?
It's normal for the heater of your Dimplex Indoor Fireplace to emit an odor briefly when initially turned on, as it burns off dust accumulated during manufacturing or operation. However, if the odor persists, the heater assembly may be defective and require replacement.
Why is the flame shuddering on my Dimplex Indoor Fireplace?
If the flame shudders on your Dimplex Indoor Fireplace, the flicker motor may be defective and require replacement.
Why is there excessive noise with my Dimplex PF3033 heater on?
Excessive noise with the heater on may be due to a dirty heater assembly. Ensure that exterior intake louvers and the fireplace cavity are free of dirt and dust. If the noise persists, the heater assembly may be defective and require replacement.
Why is there grinding or excessive noise with my Dimplex PF3033 Indoor Fireplace heater off?
Grinding or excessive noise with the heater off may be caused by the flicker rod hitting or rubbing against internal components. Ensure the rod is straight and mounted properly in the bracket, spinning freely away from other components. Replace if necessary. The flicker motor may also be defective and require replacement.
Why does the flame shudder on my Dimplex Indoor Fireplace?
If the flame in your Dimplex Indoor Fireplace shudders, it is likely due to a defective flicker motor, which will need to be replaced.
What to do if my Dimplex PF3033 Indoor Fireplace fan turns on but there is no heat?
If the fan in your Dimplex Indoor Fireplace turns on but there is no heat, the relay board or the heater assembly may be defective and require replacement.
Describes how to operate the fireplace using gesture controls.
Explains the use of the infrared multifunction remote control.
Procedure to reset the heater's automatic cutout after overheating.
General| Brand | Dimplex |
|---|---|
| Model | PF3033 |
| Category | Indoor Fireplace |
| Language | English |
To Next Page
