19
!
NOTE: Holding the and
the
buttons down for two
seconds, on the unit, will
change the temperature scale
from °C to °F, or vice versa.
F.
Eco Operation
Runs the heater in a reduced
wattage range when activated.
Adjusted by pressing the
corresponding button on the
remote when the heater is on.
• Indicated by the Display and a
reduced fan speed.
G.
Heat Boost
Turns the Heater Boost On and
Off. Runs the unit at the full rated
wattage.
Activated and adjusted by
repeatedly pressing the
corresponding button on
the remote.
• Indicated by the heater running
at full heat, for a user set
amount of time, to quickly heat
up a cold room/space. The
Heat Boost can be set for a
maximum of 20 minutes, in
5 minute increments.
D
Temperature Down
Decreases the temperature setting.
Adjusted by repeatedly
pressing the corresponding
button on the remote.*
• Indicated by set point
temperature on the Display
decreasing and the speed of
the fan decreasing to reduce
the amount of heat being
projected into the room.
E. Temperature Up
Increases the temperature setting.
Adjusted by repeatedly
pressing the corresponding
button on the remote.*
• Indicated by the set point on
the Display increasing and the
speed of the fan increasing to
increase the amount of heat
being projected into the room.**
* The rst time the button
is pressed the current
temperature set point will be
displayed for 2 seconds.
** The temperature can be
adjusted from 5 °C to 37 °C
(41 °F to 99 °F).
Operation (continued)
To Next Page
Loading...
Need help?
General
