9
4.4 MEMORY FUNCTION
4.4.1 How To Save A Weighing Result To Memory
a. Place a load on the platform. The weight appears on the display.
b. Wait for the stability signal to appear, and then press M+.
c. The weight is now saved in the memory. M+ indicator appears, indicating that the memory contains data.
d. Remove the load, and the scale will return to zero weight status.
e. Put on another weight and press M+ to save the next weight.
NOTE:
The memory function can be temporary switch off if needed, particularly when the weighing result does not need to be
saved. To disable it, press and hold M+. The display shows ACC.on. Press ZERO to select between ACC.on and ACC.oF,
and MODE to confirm.
4.4.2 How To Recall A Weighing Result From Memory
a. Press MR at anytime to recall the total result saved in the memory. MR indicator appears, showing the total saved
result.
b. The result will remain on the display for a short while, before returning to the previous screen.
4.4.3 How To Clear Weighing Result From Memory
Follow the steps below to clear saved data from memory.
a. Press MR first to recall the total saved result from memory; the MR indicator turns on.
b. Press MC immediately to clear the memory. The M+ indicator turns off, indicating there is no data in the memory
4.5 PIECE COUNTING FUNCTION
This indicator is fitted with simple piece counting function. Please follow the procedure below to enable the function and
sampling method.
a. The indicator is on, as well as the Zero and stability indicators.
b. Press MODE. The display shows PCS as weighing unit on the display.
c. Press and hold MR; the display shows S: NUMBER PCS (that may be 10, or the previous value inserted). The
number identifies the sample quantity that will be used.
d. If S: 10 or the previous value inserted has to be changed, press ZERO and the display shows S:20, S:50, S:100,
S:200, S:500 and S:1000. When the desired quantity is reached, press MODE to confirm and put the sample quantity
on the platform.
e. The display will return to normal weighing mode, with PCS indicator on, showing that the scale is in piece counting
mode.
f. Remove the load and put new batch. The display will show the batch quantity.
g. If the display shows a value while the platform is empty, press ZERO to zero the weight.
h. If a new sampling is needed, press and hold MR, and follow the procedure again, starting from step c.
NOTE:
1. If the scale detects a total weight which corresponds to a smaller number than 20d, the PCS sign will start flashing as
warning. Press the ZERO key to change the sampling quantity setting, or add more samples until the signal is off.
2. If the scale detects a sample unit piece weight which is smaller than the minimum unit weight, the PCS sign will start
flashing as warning (unit piece weight must not be smaller than 0.5d).
3. When the PCS indicator flashes, the sampling process can be carried out anyway, but there might result errors.
To Next Page
Loading...
Need help?
General
