EasyManua.ls Logo

Direct Supply ATLAS - Operation; Hand Control and Boom Operation; Leg Adjustment for Stability

Direct Supply ATLAS
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
1-800-634-7328 DirectSupply.com
Operation
WARNING: Do not attempt to transfer the resident without prior approval from a medical
professional. Do not install, assemble or operate this equipment without first reading and
understanding the instruction manual and observing trained specialists perform a lift.
WARNING: When lifting a resident, the legs of the lift must be in the maximum open position
for stability and safety. If it is necessary to close the legs of the lift to maneuver the lift under a
bed, close the legs of the lift only as long as it takes to position the lift over the resident and lift the
resident off the surface of the bed. Return the legs of the lift to the maximum open position when
the legs of the lift are no longer under the bed.
CAUTION: More than one assistant is recommended for all resident lift activities.
Hand Control Buttons
Use the up/down buttons on your lift’s hand pendant to raise and lower the lift’s boom.
WARNING: When lifting a resident, DO NOT lock the rear casters. Doing so could cause the lift to
tip and could injure the resident or assistants. The rear casters should be left unlocked during lifting
to allow the resident lift to stabilize itself when the resident is initially lifted from a chair, bed or any
stationary object.
Raising/Lowering the Boom
Press the boom up arrow to raise the boom and resident.
Press the boom down arrow to lower the boom and resident.
Opening/Closing the Legs
Opening and closing the legs requires the use of the spreader bar.
The spreader bar handle (M) is used to open the legs of the
base for stability before lifting the resident. The base legs
should be locked in the maximum open position at all times
when the resident is on the lift.
WARNING: For maximum stability, operate this lift with
the base legs in the fully open and locked position when
lifting the resident.
To open the base legs, grasp the spreader bar handle (M) in one
hand and place the opposite hand on the steering handle of the
mast for balance. Move the handle toward you and away from
the locking plate and then to the far left to open the base legs.
To close the legs to a narrow position for transport or storage,
reverse the above procedure.
Raise Lower
M

Related product manuals