22 © 2013
Directed. All rights reserved.
Enter Learn Routine (4 window mode)
1. Roll the windows down.
2. With the vehicle’s ignition on, temporarily connect the Aux channel input (H2/3 Red/White)
wire to ground. This wire must remain grounded during the entire learn procedure.
3. While the H2/3 Red/White is receiving a ground input, attempt to roll the driver window up
from the master window switch.
4. Continue holding the driver side window “up” for about two to three seconds and then release
the switch. If the window does not continue to move after you have released the switch, verify that
the H2/1 Brown input is receiving (+) or (-) when you press the switch and that the polarity dip
switch is set to the appropriate position.
5. The windows now begin to close one by one while the 535T attempts to learn the “fully closed”
positions for each window.
6. Once all of the windows have been closed by the 535T, the learn procedure has completed.
Exit Learn Routine
The learn routine is immediately canceled and stops window travel under any of the following
conditions:
• H2/3 Red/White ground ceases
• Any window switch is pressed after learn routing has begun
• If the window learn procedure detects a window failure or is unable to detect the “fully
closed” positions.
To Next Page
Loading...
