Directed DS4+ - User Manual

Questions and Answers

C
Carl BurnsAug 28, 2025
What to do if Directed DS4+ transponder functions were skipped?
- A
  Allison BrownAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
B
brandi36Aug 25, 2025
What to do if Directed Automobile Electronics is waiting to begin the programming sequence?
- M
  Mr. David BrayAug 25, 2025
  If the Directed Automobile Electronics is waiting to begin the programming sequence, ensure that the correct programming procedure is being followed.
R
ronald54Sep 23, 2025
What does it mean when my Directed DS4+ says 'MUX not detected'?
- C
  catherinejacksonSep 23, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
T
Thomas CamachoAug 31, 2025
What to do if MUX is not detected on Directed DS4+ Automobile Accessories?
- D
  Debra GarciaAug 31, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
M
Michelle WintersSep 2, 2025
Why Directed DS4+ Automobile Accessories says 'OBDII feature not supported'?
- D
  David ParkerSep 3, 2025
  The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
A
antoniosmithAug 29, 2025
What to do if Directed DS4+ Automobile Accessories CAN bus incorrectly detected?
- C
  cooperjodiAug 30, 2025
  Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
S
Stephanie FosterAug 27, 2025
What to do if Directed DS4+ Automobile Accessories module has no power?
- J
  Jaclyn LongAug 27, 2025
  First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
M
Melissa MorrisSep 4, 2025
Why is the OBDII feature not supported on my Directed DS4+?
- J
  John McleanSep 4, 2025
  The diagnostic data bus was not detected, so the SmartStart features will be limited.
T
tedwardsSep 1, 2025
Why speed was detected on Directed Automobile Accessories?
- J
  Jessica YoungSep 1, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
M
Mrs. Janice GarciaAug 26, 2025
What to do if ISO 1 is not detected on Directed Automobile Electronics?
- R
  Robert GarciaAug 26, 2025
  If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.