To Next Page
J
Jason BowmanAug 28, 2025
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
- YymillerAug 28, 2025
The Yellow/Black wire did not detect the expected signal. Check the connections.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What to do if bypass data is not detected in Directed Directechs DB3 Automobile Accessories?
If the bypass data isn't being detected by your Directed Automobile Accessories, check the bypass line connection. If multiple wires are involved, ensure they aren't inverted. Also, confirm that the vehicle still functions correctly with the factory key.
Why Directed Door locks waiting to begin the programming sequence?
Ensure the correct programming procedure is being followed for the Directed Door locks.
What to do if Directed Directechs DB3 Automobile Accessories is waiting to begin the programming sequence?
Make sure you are following the correct programming procedure.
What does it mean if Directed Directechs DB3 Automobile Accessories says ISO 2 not detected?
If the Directed Automobile Accessories system indicates 'ISO 2 not detected,' it means the Orange/Black wire did not detect the expected signal. Consult the “Installation (wiring diagrams & vehicle wiring reference charts)” to verify the connections.
Why was the smart key not detected by Directed Automobile Accessories?
The smart key was not detected, which prevents the system from shutting down the vehicle.
What does feature error mean for Directed Directechs DB3 Automobile Accessories?
If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed Automobile Accessories shows bypass processing error?
If the Directed Automobile Accessories system displays 'Bypass processing error', reset the module and try again.
What to do if Directed Automobile Accessories Key2GO initiated?
If your Directed Automobile Accessories system displays 'Key2GO initiated', please follow the steps indicated in 'Module programming' to complete the Key2GO programming.
What does ISO 2 not detected mean for Directed Directechs DB3 Automobile Accessories?
If ISO 2 is not being detected by your Directed Automobile Accessories, it means the Orange/Black wire didn't detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
