J
Jason BowmanAug 28, 2025
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
- YymillerAug 28, 2025
The Yellow/Black wire did not detect the expected signal. Check the connections.
To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What to do if bypass data is not detected in Directed Directechs DB3 Automobile Accessories?
If the bypass data isn't being detected by your Directed Automobile Accessories, check the bypass line connection. If multiple wires are involved, ensure they aren't inverted. Also, confirm that the vehicle still functions correctly with the factory key.
What to do if Directed Directechs DB3 Automobile Accessories is waiting to begin the programming sequence?
Make sure you are following the correct programming procedure.
What to do if Directed Directechs DB3 Automobile Accessories says CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
Why was the smart key not detected by Directed Automobile Accessories?
The smart key was not detected, which prevents the system from shutting down the vehicle.
What does feature error mean for Directed Directechs DB3 Automobile Accessories?
If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
What does it mean if Directed Directechs DB3 shows PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Directed Automobile Accessories Key2GO initiated?
If your Directed Automobile Accessories system displays 'Key2GO initiated', please follow the steps indicated in 'Module programming' to complete the Key2GO programming.
What does ISO 2 not detected mean for Directed Directechs DB3 Automobile Accessories?
If ISO 2 is not being detected by your Directed Automobile Accessories, it means the Orange/Black wire didn't detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why is Directed Directechs DB3 Automobile Accessories waiting to begin the programming sequence?
If the Directed Automobile Accessories system is waiting to begin the programming sequence, ensure the correct programming procedure is being followed.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
