To Next Page
J
Jennifer ButlerAug 28, 2025
What to do if Directed DS3 transponder functions were skipped?
- JJohn ChandlerAug 28, 2025
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Directed DS3 transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
What to do if Directed Automobile Electronics is waiting to begin the programming sequence?
If the Directed Automobile Electronics is waiting to begin the programming sequence, ensure that the correct programming procedure is being followed.
What does it mean when my Directed DS3 Automobile Accessories says 'MUX not detected'?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
What to do if MUX is not detected on Directed DS3 Automobile Accessories?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
Why Directed DS3 Automobile Accessories says 'OBDII feature not supported'?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
What to do if Directed DS3 Automobile Accessories CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed DS3 Automobile Accessories module has no power?
First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
Why is the OBDII feature not supported on my Directed DS3 Automobile Accessories?
The diagnostic data bus was not detected, so the SmartStart features will be limited.
Why speed was detected on Directed DS3?
The vehicle was detected as moving, which prevents the system from shutting it down.
What to do if ISO 1 is not detected on Directed Automobile Electronics?
If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
General| Remote Start | Yes |
|---|---|
| Keyless Entry | Yes |
| Shock Sensor | Yes |
| Voltage Range | 12V DC |
| Security Features | Starter Kill, Anti-Theft |
| Compatibility | Most vehicles |
