What to do if Directed Automobile Accessories bypass data not detected?
Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
Verify the CAN1 and CAN2 connections.
What to do if transponder functions were skipped on my Directed Remote Starter?
If transponder functions were skipped on your Directed Remote Starter, and if compatible, when the RXT mode is not desired or convenience features are needed, reset and reprogram the module.
Why Directed DS3 Automobile Accessories OBDII feature is not supported?
The diagnostic data bus was not detected, therefore the SmartStart features will be limited in your Directed Automobile Accessories.
What to do if Directed DS3 Automobile Accessories has DEI feature error?
Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
What causes a bypass processing error in Directed DS3?
Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if Directed DS3 transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
Why is Directed Automobile Accessories showing 'Speed was detected'?
The vehicle was detected as moving, which prevents the system from shutting it down.
What does it mean if Directed Automobile Accessories PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Directed Remote Starter is waiting to begin the programming sequence?
Make sure that you are following the correct programming procedure.
General| Remote Start | Yes |
|---|---|
| Keyless Entry | Yes |
| Shock Sensor | Yes |
| Voltage Range | 12V DC |
| Security Features | Starter Kill, Anti-Theft |
| Compatibility | Most vehicles |
To Next Page