How to troubleshoot Directed Control Unit when module has no power?
Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective.
What causes a bypass processing error in Directed DS3?
Reset the module and try again. If the condition persists, please contact Technical Support.
What to do if Directed Automobile Accessories has a DEI feature error?
A feature config file mismatch was detected. No other solution is available.
What to do if Directed DS3 Automobile Accessories module has no power?
First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
What to do if CAN1 is not detected on Directed DS3 Automobile Accessories?
Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What to do if Directed Automobile Accessories bypass data not detected?
Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
What to do if Directed DS3 Automobile Accessories has DEI feature error?
Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
What does it mean if OBDII feature is not supported in Directed DS3 Automobile Accessories?
If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
Why Directed DS3 Automobile Accessories Speed was detected?
The vehicle was detected as moving, which prevents the system from shutting it down.
Why is the OBDII feature not supported on my Directed DS3 Automobile Accessories?
The diagnostic data bus was not detected, so the SmartStart features will be limited.
General| Remote Start | Yes |
|---|---|
| Keyless Entry | Yes |
| Shock Sensor | Yes |
| Voltage Range | 12V DC |
| Security Features | Starter Kill, Anti-Theft |
| Compatibility | Most vehicles |
To Next Page