What does ISO 2 not detected mean for Directed Directechs DB3 Automobile Accessories?
If ISO 2 is not being detected by your Directed Automobile Accessories, it means the Orange/Black wire didn't detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Directechs DB3 Automobile Accessories says CAN2 not detected?
Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
What does PTS shutdown error mean on Directed Automobile Electronics?
The PTS output from the module wasn't activated due to safety protection.
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What does a feature error mean in Directed Directechs DB3?
If the Directed Automobile Accessories system indicates a feature error, an RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed Automobile Accessories says MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What does Directed Directechs DB3 start fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
What does it mean if Directed Directechs DB3 Automobile Accessories says ISO 2 not detected?
If the Directed Automobile Accessories system indicates 'ISO 2 not detected,' it means the Orange/Black wire did not detect the expected signal. Consult the “Installation (wiring diagrams & vehicle wiring reference charts)” to verify the connections.
What does feature error mean for Directed Directechs DB3 Automobile Accessories?
If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed Directechs DB3 Automobile Accessories bypass data is not detected?
Check the connection of the bypass line. If multiple wires are used, ensure they are not inverted. Also, verify that the vehicle operates correctly with the factory key.
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
To Next Page