N
Nicole HarperSep 23, 2025
Why Directed Door locks waiting to begin the programming sequence?
- DDavid GonzalesSep 23, 2025
Ensure the correct programming procedure is being followed for the Directed Door locks.
To Next PageTo Next PageWhy Directed Door locks waiting to begin the programming sequence?
Ensure the correct programming procedure is being followed for the Directed Door locks.
What to do for Directed Directechs DB3 bypass processing error?
If your Directed Automobile Accessories module shows a bypass processing error, it means the bypass calculation failed. Try resetting the module and attempting the process again. If the problem persists, further assistance may be required.
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What does Directed Automobile Accessories stop fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
What does 'ISO 2 not detected' mean for Directed Automobile Accessories?
If the Directed Automobile Accessories system indicates 'ISO 2 not detected,' the Orange/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What does it mean if Directed Directechs DB3 shows PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
What to do if ISO 2 is not detected in Directed Automobile Accessories?
The Orange/Black wire did not detect the expected signal. Check the connections.
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections.
What does feature error mean on Directed Directechs DB3 Automobile Accessories?
An RSR feature file mismatch was detected for your Directed Automobile Accessories. Please contact Technical Support.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
