To Next PageTo Next PageWhat does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Door locks waiting to begin the programming sequence?
Ensure the correct programming procedure is being followed for the Directed Door locks.
What causes bypass processing error in Directed Directechs DB3 Automobile Accessories?
If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the condition persists, please contact Technical Support.
What does it mean if Directed Directechs DB3 Automobile Accessories says ISO 2 not detected?
If the Directed Automobile Accessories system indicates 'ISO 2 not detected,' it means the Orange/Black wire did not detect the expected signal. Consult the “Installation (wiring diagrams & vehicle wiring reference charts)” to verify the connections.
What to do if MUX is not detected in Directed Directechs DB3?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
What to do if ISO 2 is not detected in Directed Automobile Accessories?
The Orange/Black wire did not detect the expected signal. Check the connections.
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
The Yellow/Black wire did not detect the expected signal. Check the connections.
Why Directed Directechs DB3 speed was detected?
The vehicle was detected as moving, which prevents the system from shutting it down.
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
Why speed was detected on Directed Automobile Accessories?
If speed was detected by your Directed Automobile Accessories, it means the vehicle was detected as moving, which prevents the system from shutting it down.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
