To Next Page
S
shanescottSep 6, 2025
What does Directed Directechs DB3 start fail mean?
- AAdam LewisSep 6, 2025
The RXT start/stop message was received by the module, but not executed on the vehicle.
What does Directed Directechs DB3 start fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
What does Directed Automobile Accessories stop fail mean?
The RXT start/stop message was received by the module, but not executed on the vehicle.
Why is my Directed Automobile Accessories module not getting power?
First, ensure the D2D harness is properly connected and verify that 12 Volts are present between the red and black wires. If the voltage is correct and the Directed Automobile Accessories module still has no power, it may be defective.
What to do if BCM programming fails on Directed Automobile Accessories?
If the BCM programming fails on your Directed Automobile Accessories, try clicking 'Unlock' on the OEM remote to solve the problem.
What causes bypass processing error in Directed Directechs DB3 Automobile Accessories?
If you encounter a bypass processing error with your Directed Automobile Accessories, reset the module and try again. If the condition persists, please contact Technical Support.
What does feature error mean on Directed Directechs DB3 Automobile Accessories?
An RSR feature file mismatch was detected for your Directed Automobile Accessories. Please contact Technical Support.
What does it mean if Directed Directechs DB3 says MUX not detected?
If the Directed Automobile Accessories system indicates 'MUX not detected', the Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if my Directed Automobile Accessories system displays 'Bypass processing error'?
The bypass calculation failed. Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
What does it mean when my Directed Directechs DB3 says 'Waiting to begin the programming sequence'?
This indicates that you should ensure the correct programming procedure is being followed for your Directed Automobile Accessories system.
What to do if my Directed Directechs DB3 Automobile Accessories system says 'Initialization failed'?
Reset the Directed Automobile Accessories module and complete the programming again. If the issue persists, please contact Technical Support.
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
