To Next PageTo Next PageWhy speed was detected on Directed Automobile Accessories?
If speed was detected by your Directed Automobile Accessories, it means the vehicle was detected as moving, which prevents the system from shutting it down.
What to do if Directed Automobile Electronics shows a bypass processing error?
If you encounter a bypass calculation failure, reset the module and try again.
Why is the smart key not detected by my Directed Directechs DB3?
The smart key was not detected, which prevents the system from shutting down the vehicle.
Why is there a PTS shutdown error in my Directed Directechs DB3 Automobile Accessories?
The PTS output from the module was not activated due to safety protection.
Why Runsafe was not disabled in Directed Directechs DB3?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What does it mean if the brake was not detected in Directed Directechs DB3?
The brakes were not detected, which prevents the system from shutting down the vehicle.
How to fix Directed Automobile Accessories when CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why is BCM programming failing on my Directed Directechs DB3?
The BCM might have failed to program. Check if the doors are unlocked. If they are locked, unlock them to solve the problem.
What to do if Directed Automobile Electronics CAN bus incorrectly detected?
Verify the CAN1 and CAN2 connections.
What to do if Directed Remote Starter transponder functions were skipped?
If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
