What to do if my Directed Automobile Accessories system shows 'ISO 1 not detected'?
The Yellow/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
Why Directed Automobile Accessories says Runsafe was not disabled?
If the Directed Automobile Accessories system indicates that Runsafety was not disabled, it means no UNLOCK command was received before opening the door, or the 45-second timer expired in takeover mode.
What does it mean if OBDII feature is not supported in Directed Directechs DB3?
If the OBDII feature isn't supported in your Directed Automobile Accessories, it means the diagnostic data bus wasn't detected, which will limit the SmartStart features.
Why is BCM programming failing on Directed Directechs DB3 Automobile Accessories?
If BCM programming is failing on your Directed Automobile Accessories, the doors may be locked. Ensure that the doors are unlocked, as they need to be unlocked to solve this problem.
What to do for Directed Directechs DB3 bypass processing error?
If your Directed Automobile Accessories module shows a bypass processing error, it means the bypass calculation failed. Try resetting the module and attempting the process again. If the problem persists, further assistance may be required.
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What does 'PTS shutdown error' mean on my Directed Directechs DB3?
The PTS output from the Directed Automobile Accessories module was not activated due to safety protection.
Why Brake was not detected in Directed Directechs DB3 Automobile Accessories?
The brakes were not detected, which prevents the Directed Automobile Accessories system from shutting down the vehicle.
Why Smart key was not detected in Directed Directechs DB3?
The smart key was not detected, which prevents the Directed Automobile Accessories system from shutting down the vehicle.
What should I do if J1850 is not detected in Directed Directechs DB3?
If the J1850 is not detected by your Directed Automobile Accessories, check the J1850 wire connection. Try waking up the data bus by turning the ignition on and trying again.
Lists all functions compatible with the vehicle for installation.
Presents an alternative wiring diagram for the DB3 module installation.
Shows alternative locations of key components within the vehicle for installation.
Lists error codes indicated by LED flashes during module programming.
Addresses troubleshooting for OBDII features and external module sync issues.
Explains LED feedback for lock, unlock, trunk, and auxiliary commands received.
Lists LED indicators for various reasons of remote start unscheduled shutdown.
Explains LED indicators for Remote Start Ready (RSR) specific error conditions.
Describes methods to send commands like lock, unlock, and remote start.
Explains the "Get In and Go" feature for seamless takeover after remote start.
Explains the functionality and benefits of the SmartStart mobile application for vehicle control.
General| Brand | Directed |
|---|---|
| Model | Directechs DB3 |
| Category | Automobile Accessories |
| Language | English |
To Next Page