Directed Directechs DB3 - User Manual

24 pages

Save Page as PDF

To Next Page

INSTALLATION GUIDE

DB3

2020 Audi Q7 (Smart Key). 403.VW08 1.35 RSR

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

Questions and Answers

D
David BarnesSep 8, 2025
What does 'Runsafe was not disabled' mean on my Directed Automobile Accessories?
- T
  Thomas WeaverSep 8, 2025
  No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
P
Phillip EllisonAug 29, 2025
Why was the smart key not detected by Directed Automobile Accessories?
- B
  bowenbrandonAug 29, 2025
  The smart key was not detected, which prevents the system from shutting down the vehicle.
K
Kayla VasquezSep 7, 2025
What to do if my Directed Directechs DB3 Automobile Accessories system says 'Initialization failed'?
- V
  Victoria LopezSep 7, 2025
  Reset the Directed Automobile Accessories module and complete the programming again. If the issue persists, please contact Technical Support.
D
Dominique KaiserSep 23, 2025
What does it mean if Directed Directechs DB3 Automobile Accessories says ISO 1 not detected?
- W
  wrightchristineSep 23, 2025
  If the Directed Automobile Accessories system indicates 'ISO 1 not detected', the Yellow/Black wire did not detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
A
Anthony MedinaSep 13, 2025
What to do if Directed Remote Starter bypass processing error?
- G
  garykochSep 13, 2025
  The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
N
Nicole HarperSep 23, 2025
Why Directed Door locks waiting to begin the programming sequence?
- D
  David GonzalesSep 23, 2025
  Ensure the correct programming procedure is being followed for the Directed Door locks.
K
klinepamAug 28, 2025
What to do if Directed Directechs DB3 CAN bus is incorrectly detected?
- R
  robert60Aug 28, 2025
  Verify the CAN1 and CAN2 connections. Check the connections.
J
jessicalewisAug 28, 2025
What to do if MUX is not detected in Directed Directechs DB3?
- J
  Jose HarrisAug 28, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
L
Lisa RiveraAug 28, 2025
What to do if ISO 2 is not detected in Directed Automobile Accessories?
- R
  Rachel OnealAug 28, 2025
  The Orange/Black wire did not detect the expected signal. Check the connections.
J
Jason BowmanAug 28, 2025
What to do if ISO 1 is not detected in Directed Directechs DB3 Automobile Accessories?
- Y
  ymillerAug 28, 2025
  The Yellow/Black wire did not detect the expected signal. Check the connections.