Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

A
Alexis GordonAug 27, 2025
What to do if Directed Automobile Accessories bypass data not detected?
- J
  Jennifer SuttonAug 27, 2025
  Check the bypass line connection. If there's more than one wire, ensure they aren't inverted. Also, make sure the vehicle still operates correctly using the factory key.
H
hbaileySep 22, 2025
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
- D
  davidleonardSep 22, 2025
  Verify the CAN1 and CAN2 connections.
K
Kelly BowmanSep 12, 2025
What does PTS shutdown error mean on my Directed Remote Starter?
- M
  Mr. Daniel WeaverSep 12, 2025
  A PTS shutdown error on your Directed Remote Starter means the PTS output from the module was not activated due to safety protection.
C
christierodriguezSep 15, 2025
Why Directed DS4+ Automobile Accessories OBDII feature is not supported?
- A
  Alejandro WalkerSep 15, 2025
  The diagnostic data bus was not detected, therefore the SmartStart features will be limited in your Directed Automobile Accessories.
B
beardlindaSep 15, 2025
What to do if Directed DS4+ Automobile Accessories has DEI feature error?
- K
  Kevin MyersSep 15, 2025
  Please contact Technical Support if you encounter a DEI feature error with your Directed Automobile Accessories.
M
Melanie ClarkSep 4, 2025
What causes a bypass processing error in Directed Automobile Accessories?
- M
  Manuel ManningSep 4, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
C
Carl BurnsAug 28, 2025
What to do if Directed DS4+ transponder functions were skipped?
- A
  Allison BrownAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
D
David WoodAug 28, 2025
Why is Directed Automobile Accessories showing 'Speed was detected'?
- K
  Kimberly BowmanAug 28, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
J
Jamie BellAug 28, 2025
What does it mean if Directed Automobile Accessories PTS shutdown error?
- S
  samanthajohnsonAug 29, 2025
  The PTS output from the module was not activated due to safety protection.
M
margaretriversSep 22, 2025
What to do if Directed Remote Starter is waiting to begin the programming sequence?
- D
  Dawn TrujilloSep 22, 2025
  Make sure that you are following the correct programming procedure.