Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

A
Amanda MoranSep 12, 2025
What to do if my Directed Remote Starter shows CAN2 not detected?
- S
  samuel13Sep 12, 2025
  If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
A
antoniosmithAug 29, 2025
What to do if Directed DS4+ Automobile Accessories CAN bus incorrectly detected?
- C
  cooperjodiAug 30, 2025
  Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
T
Thomas ChavezSep 10, 2025
What to do if ISO 1 is not detected in Directed Automobile Accessories?
- A
  ashleybarkerSep 10, 2025
  If the ISO 1 is not detected in your Directed Automobile Accessories because the Yellow/Black wire did not detect the expected signal, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.
D
Daniel ForbesSep 12, 2025
What to do if my Directed Remote Starter says CAN bus incorrectly detected?
- K
  Karen CookSep 12, 2025
  If the CAN bus is incorrectly detected by your Directed Remote Starter, verify the CAN1 and CAN2 connections.
K
Karen PayneSep 16, 2025
What does it mean 'Bypass and CAN were skipped' in Directed DS4+ Automobile Accessories?
- M
  martinjefferySep 16, 2025
  This means that the programming button was pressed 5 times to skip bypass and 5 times to skip the CAN.
J
Jeff SalazarSep 23, 2025
What to do if my Directed DS4+ Automobile Accessories module has no power?
- C
  crystalcastroSep 23, 2025
  First, check that the D2D harness is connected and that there is 12 Volts between the red and black wires. If 12 Volts is present, it is possible that the module is defective.
A
Anthony JacobsAug 29, 2025
What to do if Directed Automobile Accessories ISO 1 not detected?
- M
  Michael BurgessAug 29, 2025
  If the Yellow/Black wire did not detect the expected signal, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
J
Jamie BellAug 28, 2025
What does it mean if Directed Automobile Accessories PTS shutdown error?
- S
  samanthajohnsonAug 29, 2025
  The PTS output from the module was not activated due to safety protection.
D
David WoodAug 28, 2025
Why is Directed Automobile Accessories showing 'Speed was detected'?
- K
  Kimberly BowmanAug 28, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
C
Carl BurnsAug 28, 2025
What to do if Directed DS4+ transponder functions were skipped?
- A
  Allison BrownAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.