Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

A
Anthony MoralesSep 8, 2025
What does PTS shutdown error mean on Directed Control Unit?
- A
  Alicia TapiaSep 8, 2025
  The PTS output from the module was not activated due to safety protection.
A
angeldillonSep 8, 2025
Why smart key was not detected on Directed Control Unit?
- B
  Briana SandersSep 8, 2025
  The smart key was not detected, which prevents the system from shutting down the vehicle.
T
Tammy RobertsonSep 8, 2025
Why speed was detected on Directed Control Unit?
- S
  stevenwalkerSep 8, 2025
  The vehicle was detected as moving, which prevents the system from shutting it down.
M
Manuel KimSep 9, 2025
What to do if transponder functions were skipped on Directed Control Unit?
- M
  Michael BurkeSep 9, 2025
  (If compatible) when RXT mode is not desired or convenience features are needed, please reset the and reprogram the module.
L
Laura JonesSep 23, 2025
Why Runsafe was not disabled on Directed Remote Starter?
- R
  Rachel AllenSep 23, 2025
  No UNLOCK command was received before opening the door, or the 45 second timer expired in takeover mode.
R
Rhonda MillerSep 16, 2025
Why Directed Automobile Accessories transponder functions were skipped?
- M
  Malik HayesSep 16, 2025
  If compatible, when the RXT mode is not desired or convenience features are needed, please reset and reprogram the module.
R
ronald54Sep 23, 2025
What does it mean when my Directed DS4+ says 'MUX not detected'?
- C
  catherinejacksonSep 23, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
D
Daniel BeckSep 9, 2025
What does it mean if OBDII feature is not supported in Directed Automobile Accessories?
- L
  Lisa BatesSep 9, 2025
  If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
J
Jamie RossSep 9, 2025
What causes PTS shutdown error in Directed DS4+?
- E
  Eric FarleySep 10, 2025
  If the Directed Automobile Accessories experiences a PTS shutdown error, it means that the PTS output from the module was not activated due to safety protection.
T
Thomas ChavezSep 10, 2025
What to do if ISO 1 is not detected in Directed Automobile Accessories?
- A
  ashleybarkerSep 10, 2025
  If the ISO 1 is not detected in your Directed Automobile Accessories because the Yellow/Black wire did not detect the expected signal, check the connections using the 'Installation (wiring diagrams & vehicle wiring reference charts)'.