Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

T
Teresa PetersSep 18, 2025
What to do if CAN2 is not detected on Directed Remote Starter?
- T
  Tyrone CollinsSep 18, 2025
  Check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
A
Anthony JacobsAug 29, 2025
What to do if Directed Automobile Accessories ISO 1 not detected?
- M
  Michael BurgessAug 29, 2025
  If the Yellow/Black wire did not detect the expected signal, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
J
Jamie BellAug 28, 2025
What does it mean if Directed Automobile Accessories PTS shutdown error?
- S
  samanthajohnsonAug 29, 2025
  The PTS output from the module was not activated due to safety protection.
M
Michele ZimmermanSep 6, 2025
What to do if there is a bypass processing error on Directed Control Unit?
- C
  Christopher FernandezSep 7, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
C
Carl BurnsAug 28, 2025
What to do if Directed DS4+ transponder functions were skipped?
- A
  Allison BrownAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
R
Robert HoldenSep 13, 2025
What to do if Directed DS4+ Automobile Accessories says CAN1 not detected?
- A
  aholtSep 13, 2025
  If the Directed Automobile Accessories module reports that CAN1 is not detected, check the connections of the CAN1 Tan and Tan/Black wires. You can try to wake up the data bus by turning the ignition on and trying again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
A
angeldillonSep 8, 2025
Why smart key was not detected on Directed Control Unit?
- B
  Briana SandersSep 8, 2025
  The smart key was not detected, which prevents the system from shutting down the vehicle.
M
margaretriversSep 22, 2025
What to do if Directed Remote Starter is waiting to begin the programming sequence?
- D
  Dawn TrujilloSep 22, 2025
  Make sure that you are following the correct programming procedure.
C
Christopher AdamsSep 16, 2025
What does 'Bypass processing error' mean for Directed Automobile Accessories?
- X
  xbondSep 16, 2025
  The bypass calculation failed. Reset the module and try again. If the condition persists, please contact Technical Support.
A
April PrestonAug 27, 2025
What to do if CAN2 is not detected on Directed DS4+ Automobile Accessories?
- A
  andersonpaulAug 27, 2025
  Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.