Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

M
Mrs. Janice GarciaAug 26, 2025
What to do if ISO 1 is not detected on Directed Automobile Electronics?
- R
  Robert GarciaAug 26, 2025
  If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
M
Michelle WintersSep 2, 2025
Why Directed DS4+ Automobile Accessories says 'OBDII feature not supported'?
- D
  David ParkerSep 3, 2025
  The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
C
Carrie Smith DVMSep 23, 2025
Why Directed DS4+ waiting to begin the programming sequence?
- W
  William JohnsonSep 23, 2025
  Ensure the correct programming procedure is being followed.
A
Amanda MoranSep 12, 2025
What to do if my Directed Remote Starter shows CAN2 not detected?
- S
  samuel13Sep 12, 2025
  If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
B
Barbara PollardSep 7, 2025
How to troubleshoot Directed Control Unit when module has no power?
- M
  Matthew GravesSep 7, 2025
  Make sure the D2D harness is connected and that 12 Volt is present between the red and black wires. If 12 Volt is present, the module may be defective.
M
Melanie ClarkSep 4, 2025
What causes a bypass processing error in Directed Automobile Accessories?
- M
  Manuel ManningSep 4, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
A
Anthony MoralesSep 8, 2025
What does PTS shutdown error mean on Directed Control Unit?
- A
  Alicia TapiaSep 8, 2025
  The PTS output from the module was not activated due to safety protection.
R
rowensSep 12, 2025
What to do if my Directed Remote Starter shows that ISO 2 is not detected?
- M
  Mr. Robert WilliamsSep 13, 2025
  The Orange/Black wire didn't detect the expected signal. Check the connections.
S
Stephanie FosterAug 27, 2025
What to do if Directed DS4+ Automobile Accessories module has no power?
- J
  Jaclyn LongAug 27, 2025
  First, ensure the D2D harness is connected and that there's 12V present between the red and black wires. If 12V is present, the module might be defective.
T
tuckerstevenAug 27, 2025
What to do if CAN1 is not detected on Directed DS4+ Automobile Accessories?
- M
  marcusfrankAug 27, 2025
  Check the CAN1 Tan and Tan/Black wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.