J
Jessica SpencerSep 23, 2025
What to do if Directed Automobile Accessories has a DEI feature error?
- WwclarkSep 23, 2025
A feature config file mismatch was detected. No other solution is available.
To Next PageTo Next PageWhat to do if Directed Automobile Accessories has a DEI feature error?
A feature config file mismatch was detected. No other solution is available.
What does it mean if Directed DS4+ runsafe was not disabled?
No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
What to do if my Directed DS4+ Automobile Accessories module has no power?
First, check that the D2D harness is connected and that there is 12 Volts between the red and black wires. If 12 Volts is present, it is possible that the module is defective.
What to do if Directed DS4+ shows 'Bypass data not detected'?
Check the connection of the bypass line. If you're using more than one wire, ensure they are not inverted. Also, make sure the vehicle still works correctly with the factory key.
What to do if Directed DS4+ shows 'Bypass processing error'?
The bypass calculation has failed. Reset the module and try again.
Why is my Directed DS4+ Automobile Accessories showing 'ISO 1 not detected'?
The Yellow/Black wire did not detect the expected signal. Check the connections.
Why is my Directed DS4+ showing 'ISO 2 not detected'?
The Orange/Black wire did not detect the expected signal. Check the connections.
What does it mean when my Directed DS4+ says 'MUX not detected'?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
General| Brand | Directed |
|---|---|
| Model | DS4+ |
| Category | Automobile Accessories |
| Language | English |
Installation diagram and details for Type 1 with T-Harness.
Installation diagram and details for Type 2 with T-Harness.
Installation diagram and details for Type 3.
Installation diagram and details for Type 5 with T-Harness.
Installation diagram and details for Type 8.
LED indicators for module programming states and errors.
Troubleshooting analog feature configuration errors via LED.
Resets programming steps without affecting firmware.
Reverts firmware to default settings, requiring reconfiguration.
Programming Virtual Tach for starter motor control during remote start.
