Directed 403.NISS4HT 2.39 RSR

Questions and Answers

R
Rick RodriguezAug 28, 2025
What to do if ISO 1 is not detected in Directed Automobile Accessories?
- M
  Mercedes JordanAug 28, 2025
  The Yellow/Black wire did not detect the expected signal. Check the connections.
M
Mathew RivasAug 25, 2025
What to do if bypass data is not detected in Directed 403.NISS4HT 2.39 RSR?
- M
  Melvin CummingsAug 25, 2025
  If the bypass data isn't being detected by your Directed Automobile Accessories, check the bypass line connection. If multiple wires are involved, ensure they aren't inverted. Also, confirm that the vehicle still functions correctly with the factory key.
B
Brittany LaneSep 23, 2025
What does it mean if Directed Automobile Accessories says ISO 2 not detected?
- M
  Michael NguyenSep 23, 2025
  If the Directed Automobile Accessories system indicates 'ISO 2 not detected,' it means the Orange/Black wire did not detect the expected signal. Consult the “Installation (wiring diagrams & vehicle wiring reference charts)” to verify the connections.
P
Paula GutierrezAug 30, 2025
What to do if Directed 403.NISS4HT 2.39 RSR Automobile Accessories is waiting to begin the programming sequence?
- A
  alexanderlopezAug 30, 2025
  Make sure you are following the correct programming procedure.
T
Tara FowlerSep 1, 2025
What to do if Directed Automobile Accessories says CAN2 not detected?
- L
  Latoya MitchellSep 1, 2025
  Check the CAN2 Orange/Green and Orange/Brown wire connections. Wake up the data bus by turning the ignition on and try again. If your installation does not require this connection, skip this step by pressing the programming button 5 times.
K
Kerry ParkerAug 29, 2025
Why was the smart key not detected by Directed 403.NISS4HT 2.39 RSR Automobile Accessories?
- M
  Melissa FergusonAug 29, 2025
  The smart key was not detected, which prevents the system from shutting down the vehicle.
G
Gregory MezaAug 27, 2025
What does feature error mean for Directed 403.NISS4HT 2.39 RSR Automobile Accessories?
- M
  moorecindyAug 27, 2025
  If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
F
fparkerSep 2, 2025
What does it mean if Directed 403.NISS4HT 2.39 RSR shows PTS shutdown error?
- E
  Elizabeth MooreSep 2, 2025
  The PTS output from the module was not activated due to safety protection.
C
carpentermonicaAug 31, 2025
What to do if Directed Automobile Accessories Key2GO initiated?
- C
  Christine CoxAug 31, 2025
  If your Directed Automobile Accessories system displays 'Key2GO initiated', please follow the steps indicated in 'Module programming' to complete the Key2GO programming.
J
Jo RodriguezAug 26, 2025
What does ISO 2 not detected mean for Directed Automobile Accessories?
- T
  Tyler PachecoAug 26, 2025
  If ISO 2 is not being detected by your Directed Automobile Accessories, it means the Orange/Black wire didn't detect the expected signal. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.