To Next PageTo Next PageWhat to do if Directed 403.NISS4HT 2.39 RSR Automobile Accessories says MUX not detected?
The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
What to do if Directed Automobile Accessories says J1850 not detected?
Check the J1850 wire connection. Wake up the data bus by turning the ignition on and try again.
What does feature error mean for Directed 403.NISS4HT 2.39 RSR Automobile Accessories?
If you are experiencing a feature error with your Directed Automobile Accessories, an RSR feature file mismatch was detected. Please contact Technical Support.
What to do if Directed 403.NISS4HT 2.39 RSR Automobile Accessories bypass data is not detected?
Check the connection of the bypass line. If multiple wires are used, ensure they are not inverted. Also, verify that the vehicle operates correctly with the factory key.
What to do if CAN1 is not detected in Directed 403.NISS4HT 2.39 RSR?
Check the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
What does feature error mean on Directed 403.NISS4HT 2.39 RSR?
An RSR feature file mismatch was detected for your Directed Automobile Accessories. Please contact Technical Support.
What to do if my Directed 403.NISS4HT 2.39 RSR system displays 'Bypass processing error'?
The bypass calculation failed. Reset the Directed Automobile Accessories module and try again. If the condition persists, please contact Technical Support.
Why Brake was not detected in Directed Automobile Accessories?
The brakes were not detected, which prevents the Directed Automobile Accessories system from shutting down the vehicle.
What does it mean if Directed 403.NISS4HT 2.39 RSR shows PTS shutdown error?
The PTS output from the module was not activated due to safety protection.
What to do if Directed 403.NISS4HT 2.39 RSR CAN1 is not detected?
Check the CAN1 Tan and Tan/Black wire connections. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, you can skip this step by pressing the programming button 5 times.
General| Brand | Directed |
|---|---|
| Model | 403.NISS4HT 2.39 RSR |
| Category | Automobile Accessories |
| Language | English |
