Directed DS4+

62 pages

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers:

X
xnorrisSep 18, 2025
What to do if CAN1 is not detected in Directed Remote Starter?
- M
  Megan PorterSep 18, 2025
  Verify the connections of the CAN1 Tan and Tan/Black wires. Then, wake up the data bus by turning the ignition on and try again. If your installation doesn't need this connection, skip this step by pressing the programming button 5 times.
A
Adam TerrellSep 18, 2025
What to do if J1850 is not detected on Directed Remote Starter?
- K
  kristin22Sep 19, 2025
  Check the J1850 wire connection. Then, wake up the data bus by turning the ignition on and try again.
R
Rebecca TorresSep 18, 2025
What to do if Directed Remote Starter shows a bypass processing error?
- C
  Christopher FrostSep 19, 2025
  The bypass calculation has failed. Reset the module and try again.
M
margaretriversSep 22, 2025
What to do if Directed Remote Starter is waiting to begin the programming sequence?
- D
  Dawn TrujilloSep 22, 2025
  Make sure that you are following the correct programming procedure.
H
hbaileySep 22, 2025
Why is the CAN bus incorrectly detected in my Directed Remote Starter?
- D
  davidleonardSep 22, 2025
  Verify the CAN1 and CAN2 connections.
A
allenjackSep 22, 2025
How to fix Directed Remote Starter initialization failed?
- S
  Samuel BaileySep 22, 2025
  Reset the module and complete the programming again.
C
Christopher GarciaSep 22, 2025
Why Directed DS4+ Automobile Accessories says 'Runsafe was not disabled'?
- N
  Nancy HallSep 22, 2025
  No UNLOCK command was received prior to opening the door, or the 45 second timer expired in takeover mode.
A
Amy LambertSep 22, 2025
What does 'PTS shutdown error' mean on my Directed DS4+?
- N
  Nicholas SmithSep 22, 2025
  The PTS output from the module was not activated due to safety protection.
M
Michael SmithSep 22, 2025
Why Directed DS4+ Automobile Accessories says 'Brake was not detected'?
- S
  Scott DavisSep 22, 2025
  The brakes were not detected, which prevents the system from shutting down the vehicle.
T
Tracy ReynoldsSep 23, 2025
Why Directed Automobile Accessories says 'Smart key was not detected'?
- C
  christopher41Sep 23, 2025
  The smart key was not detected, which prevents the system from shutting down the vehicle.