Directed DS4+ - User Manual

62 pages

Save Page as PDF

To Next Page

FORD6

INSTALLATION GUIDE

This product is intended for installation by a professional installer only! Attempts to install this

product by a person other than a trained professional may result in severe damage to a vehicle’s

electrical system and components.

2017-12-13

DS4+

Main Page

Questions and Answers

N
Nicole JohnsonSep 8, 2025
Why brake was not detected on Directed Control Unit?
- T
  Tina HamptonSep 8, 2025
  The brakes were not detected, which prevents the system from shutting down the vehicle.
C
Carl BurnsAug 28, 2025
What to do if Directed DS4+ transponder functions were skipped?
- A
  Allison BrownAug 28, 2025
  If compatible and when RXT mode is not desired or convenience features are needed, reset and reprogram the module.
M
Mrs. Janice GarciaAug 26, 2025
What to do if ISO 1 is not detected on Directed Automobile Electronics?
- R
  Robert GarciaAug 26, 2025
  If the Yellow/Black wire did not detect the expected signal for the Directed Automobile Electronics, refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
A
Amanda MoranSep 12, 2025
What to do if my Directed Remote Starter shows CAN2 not detected?
- S
  samuel13Sep 12, 2025
  If your Directed Remote Starter displays a 'CAN2 not detected' message, check the connections of the CAN2 Orange/Green and Orange/Brown wires. Wake up the data bus by turning the ignition on and try again. If the installation doesn't require this connection, skip this step by pressing the programming button 5 times.
D
Daniel BeckSep 9, 2025
What does it mean if OBDII feature is not supported in Directed Automobile Accessories?
- L
  Lisa BatesSep 9, 2025
  If the OBDII feature is not supported in your Directed Automobile Accessories, the diagnostic data bus was not detected, therefore the SmartStart features will be limited.
A
antoniosmithAug 29, 2025
What to do if Directed DS4+ Automobile Accessories CAN bus incorrectly detected?
- C
  cooperjodiAug 30, 2025
  Verify the CAN1 and CAN2 connections. Refer to “Installation (wiring diagrams & vehicle wiring reference charts)” to check the connections.
T
Thomas CamachoAug 31, 2025
What to do if MUX is not detected on Directed DS4+ Automobile Accessories?
- D
  Debra GarciaAug 31, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.
M
Michelle WintersSep 2, 2025
Why Directed DS4+ Automobile Accessories says 'OBDII feature not supported'?
- D
  David ParkerSep 3, 2025
  The diagnostic data bus was not detected, therefore the SmartStart features will be limited.
M
Michele ZimmermanSep 6, 2025
What to do if there is a bypass processing error on Directed Control Unit?
- C
  Christopher FernandezSep 7, 2025
  Reset the module and try again. If the condition persists, please contact Technical Support.
R
ronald54Sep 23, 2025
What does it mean when my Directed DS4+ says 'MUX not detected'?
- C
  catherinejacksonSep 23, 2025
  The Violet/Green or Violet/Brown wire did not detect the expected voltage value. Check the connections.