Directed DIRECTECHS DS3+ - Quick Reference Guide; Sending Vehicle Commands; Get In and Go Takeover Operation; Vehicle Takeover Modes

34
933.HONDA9 2.03.195.3 2018 Acura ILX (Smart Key)
©2021 VOXX•DEI LLC. All rights reserved.
Quick Reference Guide (customer copy)
Get In and Go
Get In and Go is designed to provide users with easy takeover when entering their Push-to-Start
(PTS) equipped vehicle, once it has been remote started.
Typically, users would have to remote start their vehicle, then get inside and press the PTS button
to perform a takeover. There is therefore a physical action required to drive away. With Get In
and Go, you simply remote start the vehicle, unlock the doors, get in and go... All that's left to
do is put the gear in drive and drive off.
Pit stop/idle mode
1
Stop the vehicle in a safe parking spot and put the gear in
Park (P).
Put
gear in
Park
2
Press the Remote Start button on the transmitter.*
The parking lights will flash once to indicate the vehicle is
now in Pit Stop Mode.
Parking lights flash x1
14:36
Press Remote
Start button*
&
3
It is safe to leave the engine running and exit the vehicle
with the factory remote in hand.
Note: We recommend that you always lock the doors of
your vehicle when leaving it unattended.
14:36
Exit vehicle
with remote
* Icon and remote appearance may differ depending on the model purchased.
Sending commands to your vehicle
Whether you want to remote start the engine, lock/unlock the doors or pop the trunk, there are
3 possible ways you can send commands to your vehicle, using the:
• Factory remote.
• Aftermarket remote.
• Directed SmartStart application via your smartphone.
If applicable, you can also start the engine remotely by pressing the Lock button 3 times quickly
on your factory remote.
IMPORTANT! Vehicle takeover is not available on the 2020-2021 Honda CR-V
(Smart Key) and 2022 Honda Civic (Smart Key).
The vehicle takeover feature is NOT available in this firmware. The vehicle engine will shut
down as soon as a door is opened.
Wait at least 2 seconds before restarting the engine or an error message can appear on the
vehicle information display.
Vehicle takeover with Get In and Go
1
Close the vehicle doors, hood and trunk, then press the
Remote Start button on the transmitter to start the vehicle.*
14:36
Press Remote
Start button*
2
Press the Unlock button on the factory or aftermarket
remote.*
14:36
Press Unlock on
either remote*
Complete the following steps within 45 seconds or the vehicle will shut down.
3
Enter the vehicle, while making sure the factory remote is
inside with you.
14:36
Enter vehicle
with remote
4
Depress the brake pedal for a minimum of
3 seconds, put the car in gear and drive off.
For Manual Transmission, press and hold the clutch first,
then depress the brake pedal for a minimum
3 seconds.
Ready to
drive off
* Icon and remote appearance may differ depending on the model purchased.