Appendix D - Remote Protocols
3. Open the key file (andiamo_mc_lawo_license_xxxxxxx.dokey).
4. Click ‘Activate’ to transfer the license to the device.
Setup
The ANDIAMO.MC Dallis firmware supports both remote control from the
ANDIAMO Remote and from a Lawo mc² console or Nova router. To enable Dallis
mode, remote protocol ‘AB’ must be selected on the front panel of the device.
ANDIAMO.MC will then force the sync source to MADI Input. Please make sure
to set up a bi-directional MADI connection between the console / router and the
ANDIAMO.MC.
NOTE
If the LEDs of remote protocol ‘AB’ are blinking alternately, the firmware is in trial
mode.
ANDIAMO.MC simulates a Dallis frame with the following configuration:
• 941/53 cards in Slot 1..4
• 942/86 cards in Slot 11..14
All other slots are unused.
If you have trouble setting up your Lawo device to detect the ANDIAMO.MC,
please contact the Lawo support team - service@lawo.com.
For ANDIAMO.MC related questions please contact the DirectOut support team -
support@directout.eu.
To Next Page