39
8 Troubleshooting
GB
The control cube
switches off before
the room has been
completely
cleaned.
The sweeping robot is out of range.
Switch off the appliance, put it close to the control cube in the room to be
cleaned and switch it back on.
The signal of the control cube is being interfered with.
Ensure that the control cube is not close to TVs, telephones or under fluores-
cent tubes.
The LED on the
control cube is
emitting a red light
or will not switch
on.
The batteries in the control cube are empty.
Replace the empty batteries, ZChapter 4.2, "Inserting batteries into control
cube".
The central LED is
emitting red light to
show a fault.
The appliance has got stuck or is not in a position to return to the starting po-
sition.
Help by turning off the appliance, putting it on an open surface in the room to
be cleaned and turning it back on.
The control cube was moved whilst in operation or the signal has been inter-
rupted for another reason.
Switch off the appliance, reposition the control cube and turn back on.
All lights (illuminat-
ed buttons as well
as LEDs) are on at
the same time.
You tried to charge the appliance with another mains adapter.
Only use the mains adapter supplied with the sweeping robot to charge it.
The sweeping robot
will not charge.
The appliance is switched on.
Switch off the appliance (ZChapter 7.1, "Switching off").
The mains adapter is not plugged in properly. Check if the plug and the mains
adapter are fitted correctly in their sockets (ZChapter 4.3, "Charging the bat-
teries in the appliance").
Problem Possible cause / solution
NOTE:
If you cannot solve the problem using this table, contact us (ZPage 123, "International Service")
and describe the problem. Our staff are specially trained for such cases and can help you get to
the bottom of the matter in a targeted manner, and solve the problem. In this way, any inconven-
ience of having to send your sweeping robot to us can be avoided, and you can use it again
quicker.
Evo.book Seite 39 Donnerstag, 21. Oktober 2010 3:34 15