32
5 Before every use
5 Before every use
5.1 Attach floor cloth
Before you can work with the appliance, you
must attach a floor cloth:
1. Make sure that that appliance is switched
off.
2. Put the appliance on its back as shown
(Fig. 12).
3. Remove the floor cleaning panel from the
appliance (Fig. 12).
4. Select a dust cloth or a washing cloth.
5. Put the floor cloth selected onto a flat sur-
face so that it is flat and has no creases.
6. Put the floor cleaning panel onto the floor
cloth so that its holes point upwards
(Fig. 13).
7. Push the floor cloth into the teeth of the
floor cleaning panel (Fig. 13).
8. Attach the freshly equipped floor cleaning
panel to the base of the appliance
(Fig. 15). You will notice the magnet on
the base of the appliance attract the floor
cleaning panel.
Your sweeping robot is now ready for use.
12
Carefully
push floor
cloth in here
13
14
15
NOTE:
We recommend wiping up the dust with the
EVO before washing.
NOTE:
If you decide to use a washing cloth,
dampen it slightly with water before attach-
ing it. We advise against adding cleaning
agents.
NOTE:
Make sure that the floor cloth is uniform and
flat on the bottom of the floor cleaning
panel. Otherwise the appliance might not
clean as well as it could.
NOTE:
Ensure that the holes of the floor cleaning
panel are not covered by the floor cloth
(Fig. 14).
Evo.book Seite 32 Donnerstag, 21. Oktober 2010 3:34 15
To Next Page
Loading...
