Page 117
Testing the System
Resetting Your Receiver
1. Press and hold the receiver POWER button until the front panel lights blink.
2. Release the POWER button.
The receiver takes several minutes to reset, displays the message
“Acquiring Satellite Signal,” may download the Program Guide, and then
returns you to programming.
Point Dish and Check Switch
The Point Dish and Check Switch screens are helpful to the Customer Service
Representative. You may be asked to display these screens when you call DISH.
Even though there are items that can be changed, only change them when
specifically directed by a Customer Serivce Representative.
Warning: Running the Check Switch test while the receiver has
low or no signal results in incorrect receiver settings and causes
you to lose channels. Do not run a Check Switch test unless
directed to by a Customer Service Representative or other DISH
Network instructions.
1. Press MENU.
2. Select
System Setup.
3. Select
Installation.
4. Select
Point Dish. This screen shows you information to
help maximize your satellite signal. The bar at the bottom of
the screen tells you the signal strength. Green is a good
signal, yellow is a marginal signal, and red indicates the
signal is not acceptable or is from the wrong satellite.
To Next Page
Loading...
