Dish Network Receiver - Setting up TV1 to Operate in IR

Chapter 2
Page 46
Receiver Description and Installation
Setting Up TV1 to Operate in IR
The following instructions describe how to set up TV1 to operate only via IR,
which usually is the default operation.
1. Perform the following with an existing remote control:
a. Open the TV1 UHF Pro Setup screen by pressing MENU-6-1-6 on the
remote control.
b. Select
Disable from the TV1 UHF Pro Setup screen.
c. Select
System Info to open the System Information screen.
2. Perform the following with any compatible IR remote control (the model
name printed on the back of the remote will contain IR and not UHF) that
you intend to use to control TV1:
a. Press the RECORD button. The
Done button should be highlighted.
b. Make sure the
System Information screen shows that the Primary
Remote Address shows IR.