Page 77
Watching One Program While Recording Another
6. Press RECORD. Select one of the following:
• Select
OK to start the recording now.
• Select
Options to customize the following:
–
Stop Recording Manually—The receiver will record until you
press STOP.
–
Extend End Time—You can set the stop time for the recording.
–
Create a Recurring Timer—You can set up a timer like the one
described in Setting Up an Automatic Event Timer.
–
Record the Entire Event—The receiver stops recording at the end
of the event. This selection is available only if the receiver was
tuned to the channel at the beginning of the program.
7. Press DVR on the remote control. The DVR Event screen will open. You
should see the two programs that are recording indicated by the bright red
dot next to the listings.
8. Select a program that you recorded earlier (one that is not recording now),
then select
Start or Start Over.
9. You should now be watching a pre-recorded program while the receiver is
recording the other two events (programs).
To Next Page
Loading...
