100sx Operator’s Manual Plow - 47
Operation
Start Plowing
1. Start unit. (See “Start Unit” on page 34.)
2. Adjust throttle to low idle.
3. Check that ground drive control is in neutral.
4. Move ground drive control forward to a slow speed and lower plow blade until it begins to break the
soil.
5. Move the plow vibrator control to the ON position. PLOW WILL VIBRATE.
6. Lower the plow blade into the ground to full
depth.
7. Increase engine speed to a point with the least
plow vibration and the highest ground drive
speed possible without tire slippage.
8. Check cable for damage during plowing. Run
continuity checks on electric cable and check
pipe pressure. Damage can result from
improper operation, incorrect blade choice,
striking underground obstructions, or other
conditions.
NOTICE:
• Move slowly while lowering the plow blade into the ground.
• Do NOT move ground drive control to reverse with the blade in the ground.
• Do NOT plow with the blade partially raised.
t44om006w.eps
To Next Page
Loading...
