Drive - 48 XT1600 Operator’s Manual
Shut Down
CMW
Shut Down
1. Move all controls to neutral position.
2. Ensure lift arms are lowered to ground and ensure excavator boom lock is engaged.
3. Run engine at low idle for three minutes to cool.
4. Turn ignition switch to STOP.
5. Remove key.
NOTICE: Do not park unit on slope without lowering attachment to the ground and turning ignition switch
to STOP.
IMPORTANT: This unit has a built-in parking brake. The parking brake sets when one of these
conditions exist:
• No hydraulic pressure (engine stopped).
• Seat switch is not activated.
• Unit is in excavator mode.
To Next Page
Loading...