Systems and Equipment - 66 XT1600 Operator’s Manual
Front Attachments
1. Remove dirt and debris from hydraulic
couplers.
2. Connect male coupler on attachment to
female coupler (3) on unit.
3. Connect female coupler on attachment to
male coupler (1) on unit.
4. Connect female coupler on case drain hose
to case drain coupler (2) on unit, if
attachment requires it.
5. Ensure that connections are secure by
pulling on hoses.
Operate Attachment
See “Joysticks” on page 27 for a description of XT1600 front-attachment controls and refer to attachment
operator’s manual for specific attachment operating instructions.
Hot parts may cause burns. Do not touch until cool.
NOTICE: Hydraulic couplers, hoses and fluid may be hot. Wear gloves when connecting
and disconnecting hydraulic hoses and wait until unit has cooled before touching
hydraulic components.
NOTICE:
• Do not lift loads heavier than lift capacity for unit.
• Keep bystanders clear of work area.
• Do not walk or work under raised attachments unless lift arms are securely supported.
To Next Page
Loading...