XT1600 Operator’s Manual Systems and Equipment - 65
Front Attachments
7. Turn ignition switch off and remove key.
8. Push lock pin handles down to secure
attachment to lift plate.
9. Visually check that pins are extended through
bottom of attachment (shown).
Hydraulic Hoses
If attachment requires hydraulic power for operation, connect hydraulic hoses.
Note: If unit is equipped with hydraulic
attachment lock option, move
attachment lock switch to the lock
position. For information on this
control, see page 21.
Pressurized fluid or air could pierce skin and cause injury
or death. Stay away.
NOTICE:
• Escaping pressurized fluid can cause injury or pierce skin and poison.
• Before disconnecting a hydraulic line, turn engine off. Lower, block, or support any raised
component with a hoist. Cover connection with heavy cloth and loosen connector nut slightly to
relieve residual pressure. Catch all fluid in a container.
• Before using system, check that all connections are tight and all lines are undamaged.
• Fluid leaks can be hard to detect. Use a piece of cardboard or wood, rather than hands, to search
for leaks.
• Wear protective clothing, including gloves and eye protection.
• If you are injured, seek immediate medical attention from a doctor familiar with this type of injury.
To Next Page
Loading...